SMD3014 Tunable LED strip manufacturers tell you to first determine whether the strip is low voltage or high voltage. If it is low voltage, you can carefully observe that there are two small circles for every three LED lamp beads on the LED strip, and you can weld the wire to the top of the small circle. If it is a high voltage, it is plugged in with a pin, and the power plug is connected to the 220v working voltage.

One is all the LED strips connected in series with all LED lamp beads, connected to the constant current power controller of the capacitor ballast.
The SMD3014 Tunable LED strip manufacturer tells you to insert the two pins of the controller power plug into the cores of the two wires of the led light strip according to the proper optical rotation, and then insert the controller power plug into the 220V AC power plug can.
The manufacturer of SMD3014 Tunable LED strip tells you that the other is that the LED lamp beads are mixed and connected in series with multiple resistors. It requires the LED strip of the 12V DC power supply system. Match the two output lines of the 12V DC regulated power supply to receive the LED. Just plug the power cord plug into the 220V AC power plug on the positive and negative terminal blocks of the light strip, and you can also use a 12V lithium battery pack to drive this type of led light strip immediately.
1. When the led light strip has not been disassembled, in other words, it is disassembled but it is still stacked and has not been separated. In this case, the led light strip cannot be plugged in, otherwise it is very easy to cause excess An accident occurs. The manufacturer of SMD3014 Tunable LED strip tells you that before cutting the LED led strip, you must measure the amount that must be applied in each place, in order to prevent waste.
2. The SMD3014 Tunable LED strip manufacturer tells you that when the LED strip is connected, it can be connected to the switching power supply. At this time, it does not mean that the installation is over, and the top of the LED strip must be bent up and down to allow the LED strip. The route with the inner part can be exposed to the outside, and then it should be cut off with pliers to ensure that the upper edge does not contain burrs, and the connection with the male pin can be very good to avoid short-circuit failure.
3. For the installation of LED light strips, it is also important to pay attention. Only the LED light strips of the same specification and working voltage are connected in series, and the length of the series connection is to ensure that it is within the scope of larger approved applications. SMD3014 Tunable LED strip manufacturers tell you that in addition, install a pvc tail plug at the end of the LED strip, and use it to fasten it.