The Side Edge LED Rigid Strip for Light Box manufacturer tells you that there are many accessories for LED strips, such as lamp beads, wires, resistors and others. The manufacturer of Side Edge LED Rigid Strip for Light Box tells you that in general, the high-voltage strip is 100 meters per roll, and the low-voltage strip is mostly 5 meters. Before we go to buy, you can measure the size you need, and then let the merchant cut it for you.

The manufacturer of Side Edge LED Rigid Strip for Light Box tells you that the LED strip is a more advanced cold light source. It does not radiate a lot of infrared and ultraviolet like incandescent lamps and fluorescent lamps. It has almost no current heating effect like incandescent lamps, and will not be heated or cold. The impact of shrinking and frying bubbles. It will not make the bulb yellow, will not accelerate the aging of the lamp, and will not cause a greenhouse effect on the surrounding environment.
Side Edge LED Rigid Strip for Light Box manufacturers tell you that different LED strip manufacturers have different LED strip specifications, so you must pay attention when choosing. Specifications mainly refer to the number of lamp beads per meter. The prices of different specifications of LED strips are different. , This is also an important factor to distinguish the price of led lights.
The Side Edge LED Rigid Strip for Light Box manufacturer tells you that because it is usually a group of 3 LEDs, if it is 50 lights, there will be a group of insufficient quantity, but if it becomes a group of two LEDs, the limit will be increased. The resistance value of the current resistance will cause a waste of resources. Therefore, when making customized LED strips with special requirements, you must pay attention to the number of lamp beads is a multiple of 3, so as not to cause a waste of voltage resources.
The Side Edge LED Rigid Strip for Light Box manufacturer tells you that in addition to the leakage and short-circuit phenomenon of the printed board of the LED strip and the metal part on the back of the strip, single and multiple LEDs can be short-circuited or open, and the lamp can be replaced. Bead method, but the premise is that you must have the same type of led lamp beads, and you must have operating experience and tools. The tools are soldering station and air gun. The Side Edge LED Rigid Strip for Light Box manufacturer tells you that if you use an ordinary soldering iron to solder, the pins at both ends of the led lamp bead can be welded, but the heat dissipation on the back of the led lamp bead is not welded, and the lamp bead’s service life will not be long, because the led The life of the light bar depends on the temperature.